Air Conditioners - Air Conditioners

GE Zoneline Sub-Base

Made of heavy gauge steel to provide support of the wall case, Full base enclosure with break-away side channels, Simple connection to wall case, 4-point leveling legs, Adapts to service conduit, circuit breakers and receptacles up to 30 amps

GE 265 Volt Sub-Bases with Power Cord Included, 30 amp

Sub-base adapts to service conduit, circuit breakers and receptacles up to 30 amps, Made of heavy-gauge steel, Full base enclosure with breakaway side channels, 4-point leveling legs, Required distance between finished floor and sleeve: min 3" and max 5"

GE Zoneline Standard Sub-Base

Made of heavy gauge steel to provide support of the wall case, Full base enclosure with break-away side channels, Simple connection to wall case, 4-point leveling legs, Adapts to service conduit, circuit breakers and receptacles up to 30 amps

GE 15A DIRECT CONNECT KIT

4-pin connector with three 7" 12-gauge conductor wires and low-voltage personality plug,

GE 15A LCDI CORD

Six-foot power cord with LCDI, 4-pin connector, Low-voltage personality plug, 15 Amps,

GE 20A Direct Connect Kit

4-pin connector with three 7" 12-gauge conductor wires and low-voltage personality plug,

GE 20A LCDI Cord

Six-foot power cord with LCDI, 4-pin connector, Low-voltage personality plug, 20 Amps,

GE 30A DIRECT CONNECT KIT

4-pin connector with three 7" 12-gauge conductor wires and low-voltage personality plug,

GE 30A LCDI CORD

Six-foot power cord with LCDI, 4-pin connector, Low-voltage personality plug, 30 Amps,

GE Zoneline Air Deflector Kit

Adapts chassis for use with older GE architectural grilles, Aluminum deflectors are installed to the condenser end sheet flanges to prevent condenser airflow recirculation, Allows some custom (non-standard) rear grilles to be used provided they have sufficient open area,

GE RAC Zoneline Direct Connect Junction Box (230 & 265V)

GE Zoneline Duct Extension, Register and Trim Flange

Includes air register and trim flange for secondary space, Additional air register and trim flange can be ordered separately if two extensions are made, For use with RAK6053,

GE Zoneline Register and Trim Flange

Includes air register and trim flange for secondary space, For use with RAK6053, Additional air register and trim flange can be ordered separately if two extensions are made, For use with RAK6053,

GE Zoneline Duct Adapter

Recommended to be used with remote thermostat for optimal performance, Allows Zoneline unit to heat or cool an adjacent room, Attaches to top of wall case, Can be applied to right or left of adapter,

GE Duct Adapter for Replacement of A-B with Slanted-Front AZ Chassis

Recommended to be used with remote thermostat for optimal performance, Lines up with the duct extension where original chassis was a flat-top discharge A-B Series, Allows existing duct extension to be used without requiring relocation of wall hole, Must use discharge grille, end plate and extension mounting hardware from old duct adapter,